Detailed mounting kit for your Radar Arch from Krypt T Tops

Step 2: Attach the 4 through-hole feet to the 2 H legs.

Step 3: Decide where you will install the radar arch.

The mounting width is normally 82in-109in adjustable, however, you can cut the horizontal arms or the H-section to make the tower narrower to fit your boat.

Use the H leg as a tool to mark the location of the front and rear mount. The mount can be top or side mounted, just make sure the surface is flat to allow the round mount to sit well. 

Measure the width from left to right where you will mount the radar arch.

Tips:

1. For proper installation of your boat accessory, ensure the mounting position is symmetrical, using the front or rear of the boat as a reference.

2. There should be no wire or any block under the deck.

Step 4: Assemble the tower on the ground. 

Insert the 4x L arms into the H top section, keep them loose, and then attach the 2x H legs to the arms. You cannot reverse the order, or you will find it hard to insert the horizontal arms into the H section.

Lift the tower and adjust the width as close as your previous measurement.

DO NOT tighten any bolts at this stage.

Step 5: Reconfirm the exact location for the 4x deck mounts.

We recommend you attach the deck mounts to the legs and use them as a tool to mark the 4x positions, or measure the exact distance between the center point of the front and rear mount.

Keep in mind that the left and right must be symmetrical and square. And ensure the nylon washer and nylon plate parts are assembled in the correct order, which will help you fold the tower in the future.

Step 7: Attach the tower legs to the mounts, then square the tower.

Note that a wakeboarding tow eye is included in the package; you can discard it or assemble it upside down, in case it blocks your radar installation. You can also use it as a center reference to make sure the H section sits in the middle of the tower, then drill holes through the H section and horizontal arms and connect them with the 8x long bolts and nuts.

Step 8: Tighten all bolts for your boat accessory.

How to fold the tower

Disassemble the front or rear feet from the deck mounts, you can push down the tower in the opposite direction.

Contact our team at Krypt T Tops if you have any questions about our T Top accessories, the installation process, or need help with your specific boat year, make, and model. 

(843)948-6920 USA

Available Monday-Friday 9 am-5 pm EST

Krypt T-Tops 

104 Pinnacle Way Suite B Summerville, SC 29483