Dolphin Rod Holder Installation Guide

DOLPHIN T TOP ROD HOLDERS INSTALLATION







Disassembled view for your reference


STEP 1: Prepare for T Top rod holders installation
Unpack and check the contents of the box to prepare for your T Top rod holder Installation as soon as your product is received from Krypt T Top.

Please read all instructions before completing your T Top rod holder installation

If you are NOT sure of any part of the guide, or you have any questions, please contact our team at Krypt T Top or DOLPHIN T Tops

PARTS LIST


STEP 2: Ball clamp assembly for your T Top rod holder
 

To assemble the clamp, use two M6 bolts to attach its two C-sections. A rubber collar can be inserted around the inside of the ball clamp if needed for a better fit.

NOTE: The raised lip of the rubber collar will fit nicely around the edge of the clamp.
NOTE: The edges of the joint should be in line; if not, turn one of the C sections around.


STEP 3: ATTACHING THE BALL CLAMP TO THE T TOP ROD HOLDERS



Attach the ball clamp to the twin rod holder by inserting the two locator lugs into holes on the
rod holder bracket. On the other side of the twin holders,

Then insert the bolt through the hole, thread it into the clamp, and tighten.

NOTE: The clamp has two location lugs with a threaded center hole. The twin holder has a hole to insert the bolt into the clamp. You can adjust what angle you require later.

STEP4: ATTACHING TWIN ROD HOLDERS TO T TOP.

Your Dolphin T-Top uses a 2-inch clamp and a rubber collar for attachment. The rubber collar's outer lip is designed to fit snugly around the clamp, creating a secure connection to your Dolphin T-Top.

Your Dolphin T-Top is ready for t-top rod holders from Krypt T Top!

It has four designated areas at the back of the top frame for twin rod holders, allowing you to hold up to eight fishing rods. There are also mounting positions at the front if you need them. Attaching these boat t top accessories is straightforward and quick:

  1. First, place the rubber collar around the T-Top's top frame.
  2. Next, put one half C-section of the clamp on top of the rubber collar.
  3. Then, use the two bolts to attach it to the other half of the clamp, which holds the rod holder.

Once installed, you can rotate the clamp around the tube to angle your rod holders exactly where you want them. For the outer rods, you can even adjust the lugs within the clamp to angle them away from the boat as needed.


WARNING:
Remove your rods when towing the boat behind your vehicle.

Ensure your rods will not bounce out of your holders whilst using your boat.

Check that your rod holders are on tight before using your boat.

Care and maintain your racks. Clean with soapy water, rinse, and dry.

Use a marine clear protection spray on bolts for best maintenance.

WARRANTY

Dolphin T Tops warrants the product (not including other 3rd party accessories) against manufacturing defects. To claim, you must contact our team or Dolphin T Tops directly. The product/part is to be sent to the Distributor for inspection, where it will either be repaired or replaced. (Unless otherwise agreed in writing) The customer is liable for the costs associated with shipping the product/part to Dolphin T Tops.

Dolphin is not responsible for personal injury or damage to the boat caused by the use of the T Top, any transport charges, or cost of installation or removal of the T Top. Dolphin is not liable for direct, indirect, or consequential damages resulting from delay or improper T Top installation.

Our warranty doesn't cover the anodized, polished, or powder-coated finishes on surfaces, nor does it cover hardware corrosion. This is because their proper care and usage are beyond our control.

Our warranty specifically excludes spider coat gel cracking and any damage that occurs during the installation or use of the T-Top on your vessel.

Be aware that no dealer, retailer, or manufacturer can extend or alter the terms of this warranty. This is our sole warranty, superseding all others.

 


Contact our team at Krypt T Top if you have any questions about our products, the installation process, or need help with your specific boat year, make, and model. 

(843)948-6920 USA

Available Monday-Friday 9 am-5 pm EST

Krypt T-Tops 

104 Pinnacle Way Suite B Summerville, SC 29483