Dolphin Universal Radar Arch - 74 inch Installation Guide

Universal Radar Arch - 74in Installation Guide

 

Before the installation of your boat accessories, please read the following tips carefully.

1. You will receive 2 separate packages for this radar arch, one is big for the top sections and legs, which is also a standard wakeboard tower, including your full mounting kit for standard wakeboard tower installation. The other carton is smaller, which includes a pair of base bars and a mounting kit for a pontoon boat. The 4x L brackets are used for pontoon boats only; you may disregard them and use the standard round deck mounts.

2. The tow point is removable. If you use the tower as a radar arch, you can discard the tow eye or install it upside down in case it blocks your radar installation.

The larger package will include the following boat accessory parts

 

Detailed mounting parts in this package

 

The smaller package will include the following parts

 

Detailed mounting parts in this package

Step 1: Prepare for the installation of the T Top accessories
Unpack and check the contents of the box to prepare for the installation of your radar arch as soon as your product is received from Krypt T Tops.

Please read all instructions before completing your T Top accessory installation

If you are NOT sure of any part of the guide, or you have any questions, please contact our team at Krypt T Tops or DOLPHIN T Tops


Step 2: To start the installation of your boat accessory, attach the 4x through-hole feet to the 2x base bars.

 

Step 3: Decide where you will install the radar arch.

The mounting width is adjustable but is normally 82in-109in.

If needed, you can cut the horizontal arms or the H-section to make the tower narrower to fit your boat best. 

Use the U-shape leg as a tool to mark the location of the front and rear mount. The mount can be top or side mounted, just make sure the surface is flat to allow the round mount to sit well. Measure the width from left to right where you will mount the radar arch.

Tips:

1. You must make sure the mounting position is symmetrical, using the front or rear of the boat as a reference.

2. Ensure there are no wires or any blocks under the deck.

 

Step 4: Assemble the boat accessory on the ground. 

Insert the 4x L arms into the H top section, keep them loose, and then attach the 2x H legs to the arms. You cannot reverse the order, or you will find it hard to insert the horizontal arms into the H section. 

Lift the tower and adjust the width as close as your previous measurement. 

DO NOT tighten any bolts at this stage.

 

 

Step 5: Reconfirm the exact location for the 4x deck mounts.

We recommend you attach the deck mounts to the U-shaped base bars and use them as a tool to mark the 4x positions, or measure the exact distance between the center point of the front and rear mount. Keep in mind that the left and right must be symmetrical.

And make sure the nylon washer and nylon plate parts are assembled in the correct order, which will help you fold the tower in the future.

Step 7: Attach the 2x base bars to the deck mounts.

 

Step 8: Attach the top tower to the base bars.

Note that a wakeboarding tow eye is included in the package; you can discard it or assemble it upside down, in case it blocks your radar installation.

You can also use it as a center reference to make sure the H section sits in the middle of the tower, then drill holes through the H section and horizontal arms and connect them with the 8x long bolts and nuts.

 

Step 9: Tighten all bolts on your boat accessory.

Contact our team at Krypt T Tops if you have any questions about our T Top accessories, the installation process, or need help with your specific boat year, make, and model. 

(843)948-6920 USA

Available Monday-Friday 9 am-5 pm EST

Krypt T-Tops 

104 Pinnacle Way Suite B Summerville, SC 29483